LF means “long fill” on Whirlpool washers covered by the manufacturer’s LF guidance: the machine is taking too long to reach the expected water level. Whirlpool also groups F8 E1 with this fill alert. The code identifies a filling problem; it does not, by itself, tell you to buy a new inlet valve or control board.
Check water supply before trying a reset
Whirlpool advises checking that both inlet hoses are connected and both hot and cold supplies are turned on for the models covered by its guidance. Inspect visible hoses for kinks. A cold-wash selection is not a reason to assume that a required hot-water connection can be omitted.
Use the model number to confirm the requirements in your installation instructions. Leave hose disconnection and internal component testing to someone equipped to control the water supply safely.
Why can LF appear while water is entering?
An incorrectly installed drain hose can allow water to siphon out while the washer fills. Compare the hose placement with your model’s installation guide, including insertion depth and standpipe height. Do not seal the drain opening with tape. These checks come from Whirlpool’s LF troubleshooting guidance.
What if the lid is locked and the pump runs?
Whirlpool describes a pump-out period with a locked lid on the washers covered by that guidance. Do not force the lid. Follow your model’s instructions and allow the recovery sequence to finish. Repeatedly interrupting it is not a diagnosis.
If the code returns, collect these details
Before arranging a visit, take a photo of the code and write down when it appears: immediately after starting, partway through filling, or after a particular cycle selection. Also note recent changes, such as moving the washer, plumbing work or a water outage. Report those changes as observations, not proof of a failed part.
- The complete model number and code as displayed.
- Whether you hear incoming water.
- Whether water appears to drain during filling.
- Whether the issue happens on every attempted cycle.
Ask for diagnosis before approving replacement parts. Clearing a code and completing a normal cycle are different outcomes; tell the technician which one you observed.
For a different message, use our Whirlpool washer error-code guide. If the machine fills but never begins washing and shows no LF message, see the separate guide to a washer that fills but will not start.



